1 / 9

Sodium all-sky imager for the South Pole station

Sodium all-sky imager for the South Pole station. Biff Williams, NWRA/CoRA, Boulder, Colorado In collaboration with: Scott Palo and the meteor radar group at CU, Boulder Diego Janches, NWRA/CoRA, Boulder John Plane, University of Leeds, U.K Funded by OPP under NSF grant ANT-0538672.

yvon
Télécharger la présentation

Sodium all-sky imager for the South Pole station

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Sodium all-sky imager for the South Pole station Biff Williams, NWRA/CoRA, Boulder, Colorado In collaboration with: Scott Palo and the meteor radar group at CU, Boulder Diego Janches, NWRA/CoRA, Boulder John Plane, University of Leeds, U.K Funded by OPP under NSF grant ANT-0538672 NWRA/CoRA South Pole Workshop 2007

  2. Science Goals • Main Goal: Sodium abundance at South Pole • Look for azimuthal variation in Na abundance • Previous lidar measurements showed the winter sodium abundance to be twice as large as models. • Wind convergence or meteor influx at the pole might supply additional sodium • Use Na nightglow and model to calculate Na abundance • Measure meteor influx and wind convergence with CU meteor radar • Secondary Goal: Atmospheric dynamics • Images of gravity wave intrinsic parameters and breaking • Tertiary Goal: We could provide auroral 557nm images, if necessary. NWRA/CoRA South Pole Workshop 2007

  3. Imager: Keo Sentry 3i • Popular for nightglow and auroral studies • Telecentric all-sky system with six 3” filters • Size: 34” long, 12” wide. Weight: 28 pounds • Low power draw: ~1kW mostly from water chiller and computer NWRA/CoRA South Pole Workshop 2007

  4. CCD Camera • Finger Lakes Proline 1001E • Kodak KAF 1001E CCD chip • 1024x1024 pixels, 25x25mm • ~70%QE at 589nm, blue enhanced • lower dark noise than SITe chips • Cooling: 240K to reduce dark noise • double Peltier cooler (-50C) • Water chiller at ~5C • Bin pixels 2x2 on chip to reduce read noise and data rate • New, cost-effective design, but reliability of cooler and vacuum seal needs to be tested. NWRA/CoRA South Pole Workshop 2007

  5. Filter Wheel • 6 position filter wheel, 3 slots open • Filter wheel temperature controlled at slightly above ambient • Na (D1 + D2) filter: 589nm, 2nm FWHM, T=81% • Na background: 572nm, 2nm FWHM, T=82% • Green line: 557nm, 2nm FWHM • Old 2in filter, so 1200 FOV • Occasional 15 sec exposures for OI nightglow or aurora • Any other wavelengths of interest to other groups? NWRA/CoRA South Pole Workshop 2007

  6. Software and Data Rate • Linux operating system • Command line C program to move filter wheel (RS232) and run camera (USB) • Images are 512 x 512 x 16 bit = 0.5 MB • Image cadence: every 1-2 min when dark • About 0.7 GB/day (worst case) saved to external hard drive • Swap external drive each summer • Small status text file to download daily • Download thumbnail images if possible NWRA/CoRA South Pole Workshop 2007

  7. Calibration for sodium abundance • Operate the imager near the sodium lidars at ALOMAR, Norway (69N) and Colorado (40N) • Determine empirical relation between imager counts and Na density • Correction for South Pole: • different temperatures (measured by FPI) • atomic O concentrations (modeled) • atmospheric transmission • Hotpay2 rocket campaign in Norway • Na photometers on rocket give height profile of Na nightglow • Ground based Na spectrometer • Scheduled for October, possibly delayed. NWRA/CoRA South Pole Workshop 2007

  8. Site Considerations • Dark skies (1-2 min exposures) • 6-12 inch hole in the roof (size depends on roof thickness) • Clear view to within 200of horizon • Imager is automated, so maintenance access in the winter would be helpful, but not required. NWRA/CoRA South Pole Workshop 2007

  9. Current Status and Plans • System and software being tested at CoRA. • Next week: Ship to ALOMAR (69N) in Norway for testing and calibration with the Na lidar over the winter. • March 2008: Ship back to Colorado for further testing with the CSU Na lidar over the summer. • Aug 2008: Ship to South Pole. • Jan 2009: Travel to South Pole to install. • Run at South Pole for 3 or more years. NWRA/CoRA South Pole Workshop 2007

More Related