1 / 1

Interface for Multi-Purpose Driver/Data Acquisition System (P09311)

Interface for Multi-Purpose Driver/Data Acquisition System (P09311). Control Unit. Project Description:

zubeda
Télécharger la présentation

Interface for Multi-Purpose Driver/Data Acquisition System (P09311)

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Interface for Multi-Purpose Driver/Data Acquisition System(P09311) Control Unit Project Description: The goal of this project is to design, develop and implement USB and Bluetooth communication interfaces for an FPGA-based driver/data acquisition system. The data transfer rate and signal information is displayed on a GUI output and stored in a text file for analysis in ASIC and Robotics testing. • Specifications: • 8Mb/s USB transfer rate • Minimum 1.2kb/s (preferred 921kb/s) Bluetooth transfer rate • 12-bit Analog data resolution • Capable of handling a 10kHz input signal • 100% data message transfer FPGA • Hardware: • Xilinx Spartan-3 FPGA Board • P08311 Student-Designed DAQ Board • DLP Designs USB 245M Device • Parani ESD1000 Bluetooth Module • RS232 Serial PC Interface (BT) USB FIFO Output Subsystem USB Data Routing Logic Input Conditioning DAQ USB Cable PC Serial UART Input Subsystem Output Conditioning Tx Tx Bluetooth Wireless Rx Rx Conclusion: The Bluetooth communication device was measured to transfer data at 100 kb/s. The theoretical value of 330 kb/s was limited by the baud rate, and practical values were below this. However, the value is over 80 times faster than the minimum customer requirement. With further work, the USB system can handle the full load of the DAQ (7,200 kb/s), which is a feat the Bluetooth device can not achieve. The system, as a whole, meets customer specifications beyond the USB device. Pictured (L to R): Adam Van Fleet (Lead), Andrew Weida, Michael Doroski,, David Howe, T.J. Antonoff Acknowledgements: A special thanks to Dr. Lukowiak, Dr. Peskin, Dr. Reddy and Prof. Slack for their assistance in project development and team guidance.

More Related