1 / 3

1st solution. Cut internal to the plate with startup hole

1280 pezzi. 1st solution. Cut internal to the plate with startup hole. W foil 87.55 mm square. 41.75. NOT in the middle Vacuum tool has aspiration holes in the middle. Start hole diam.~1mm. EDM slot, midway between both sides, stopped 2 mm from each side, cut with 0.2mm wire.

adem
Télécharger la présentation

1st solution. Cut internal to the plate with startup hole

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. 1280 pezzi 1st solution. Cut internal to the plate with startup hole W foil 87.55 mm square 41.75 NOT in the middle Vacuum tool has aspiration holes in the middle Start hole diam.~1mm EDM slot, midway between both sides, stopped 2 mm from each side, cut with 0.2mm wire =760mm 270mm A.Brez INFN Pisa Test on 0.1mm W sample

  2. 2nd solution with 2 cuts No start hole 2 slots 2mm out of center Symmetric 1mm 4mm 270mm A.Brez INFN Pisa Test on 0.1mm W sample

  3. conclusions The 2 possibilities have been successfully tested The amount of removed material is negligible: 0.27mm/87.55mm = 0.3% (the fluctuation on plate thickness is ~±3%) The second solution is preferred (cost, symmetry, preferred by manufacturer) A.Brez INFN Pisa

More Related