1 / 34

Active Microwave Remote Sensing

Active Microwave Remote Sensing . Lecture 8 Oct 28, 2006. Recap: passive and active RS. Passive : uses natural energy, either reflected sunlight (solar energy) or emitted thermal or microwave radiation. Active : sensor creates its own energy Transmitted toward Earth or other targets

baylee
Télécharger la présentation

Active Microwave Remote Sensing

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Active Microwave Remote Sensing Lecture 8 Oct 28, 2006

  2. Recap: passive and active RS • Passive: uses natural energy, either reflected sunlight (solar energy) or emitted thermal or microwave radiation. • Active: sensor creates its own energy • Transmitted toward Earth or other targets • Interacts with atmosphere and/or surface • Reflects back toward sensor (backscatter) • Advantages: all weathers and all times

  3. Widely used active RS systems RADAR: RAdio Detection And Ranging (read p285 for an explanation) Long-wavelength microwaves (1 – 100 cm) LIDAR:LIght Detection And Ranging Short-wavelength laser light (UV, visible, near IR) SONAR: SOund Navigation And Ranging (Chapter 9): (very long wave, low Hz) Sound can not travel through vacuum Earth and water absorb acoustic energy far less than EMR energy Seismic survey use small explosions, record the reflected sound Medical imaging using ultrasound Sound waves through a water column. Sound waves are extremely slow (300 m/s in air, 1,530 m/s in sea-water) Bathymetric sonar (measure water depths and changes in bottom topography ) Imaging sonar or sidescan imaging sonar (imaging the bottom topography and bottom roughness)

  4. Types of radar • Nonimaging radar • Traffic police use handheld Doppler radar system determine the speed by measuring frequency shift between transmitted and return microwave signal • Plan position indicator (PPI) radars use a rotating antenna to detect targets over a circular area, such as NEXRDA • Satellite-based radar altimeters (low spatial resolution but high vertical resolution) • Imaging radar • Usually high spatial resolution, • Consists of a transmitter, a receiver, one or more antennas, GPS, computers

  5. Microwaves Band Designations (common wavelengths Wavelength () Frequency () shown in parentheses)in cm in GHz _______________________________________________ Ka (0.86 cm) 0.75 - 1.18 40.0 to 26.5 K 1.18 - 1.67 26.5 to 18.0 Ku 1.67 - 2.4 18.0 to 12.5 X (3.0 and 3.2 cm) 2.4 - 3.8 12.5 - 8.0 C (7.5, 6.0 cm) 3.8 - 7.5 8.0 - 4.0 S (8.0, 9.6, 12.6 cm) 7.5 - 15.0 4.0 - 2.0 L (23.5, 24.0, 25.0 cm) 15.0 - 30.0 2.0 - 1.0 P (68.0 cm) 30.0 - 100 1.0 - 0.3

  6. Two imaging radar systems In World War II, ground based radar was used to detect incoming planes and ships. Imaging RADAR was not developed until the 1950s (after World War II). Since then, side-looking airborne radar (SLAR) has been used to get detailed images of enemy sites along the edge of the flight field. SLAR is usually a real aperture radar. The longer the antenna, the better the spatial resolution • Real aperture radar (RAR) • Aperture means antenna • A fixed length (for example: 1 - 15m) • Synthetic aperture radar (SAR) • 1m (11m) antenna can be synthesized electronically into a 600m (15 km) synthetic length. • Most (air-, space-borne) radar systems now use SAR.

  7. Polarization • Unpolarizedenergy vibrates in all possible directions perpendicular to the direction of travel. • The pulse of electromagnetic energy is filtered and sent out by the antenna may be vertically or horizontallypolarized. • The pulse of energy received by the antenna may be vertically or horizontallypolarized • VV, HH – like-polarized imagery • VH, HV- cross-polarized imagery

  8. 1. RAR: Principle of SLAR

  9. Radar Nomenclature and Geometry Radar Nomenclature • nadir • azimuth (or flight) direction • look (or range) direction • range (near, middle, and far) • depression angle () • incidence angle () • altitude above-ground-level, H • polarization Azimuth flight direction Look/Range direction  Flightline groundtrack  Near range Far range

  10. Slant-range vs. Ground-range geometry Radar imagery has a different geometry than that produced by most conventional remote sensor systems, such as cameras, multispectral scanners or area-array detectors. Therefore, one must be very careful when attempting to make radargrammetric measurements. • Uncorrected radar imagery is displayed in what is called slant-range geometry, i.e., it is based on the actual distance from the radar to each of the respective features in the scene. • It is possible to convert the slant-range display into the true ground-range display on the x-axis so that features in the scene are in their proper planimetric (x,y) position relative to one another in the final radar image.

  11. Most radar systems and data providers now provide the data in ground-range geometry

  12. Range (or across-track) Resolution • t.c called pulse length. It seems the short pulse length will lead fine range resolution. • However, the shorter the pulse length, the less the total amount of energy that illuminates the target. Pulse duration (t) = 0.1 x 10 -6 sec t.c/2 t.c/2

  13. Azimuth (or along-track) Resolution • The shorter wavelength and longer antenna will improve azimuth resolution. • The shorter the wavelength, the poorer the atmospheric and vegetation penetration capability • There is practical limitation to the antenna length, while SAR will solve this problem.

  14. 2. SAR A major advance in radar remote sensing has been the improvement in azimuth resolution through the development of synthetic aperture radar (SAR) systems. Great improvement in azimuth resolution could be realized if a longer antenna were used. Engineers have developed procedures to synthesize a very long antenna electronically. Like a brute force or real aperture radar, a synthetic aperture radar also uses a relatively small antenna (e.g., 1 m) that sends out a relatively broad beam perpendicular to the aircraft. The major difference is that a greater number of additional beams are sent toward the object. Doppler principles are then used to monitor the returns from all these additional microwave pulses to synthesize the azimuth resolution to become one very narrow beam.

  15. Azimuth resolution is constant = D/2, it is independent of the slant range distance,  , and the platform altitude.

  16. Animation of the Doppler Effect

  17. Animation of the Doppler Effect

  18. Animation of the Doppler Effect

  19. Animation of the Doppler Effect

  20. Animation of the Doppler Effect

  21. Animation of the Doppler Effect

  22. Animation of the Doppler Effect

  23. Animation of the Doppler Effect

  24. Fundamental radar equation t

  25. Amount of backscatter per unit area

  26. Intermediate

  27. Penetration ability to forest Response of A Pine Forest Stand to X-, C- and L-band Microwave Energy

  28. Penetration ability into subsurface

  29. Penetration ability to heavy rainfall SIR-C/X-SAR Images of a Portion of Rondonia, Brazil, Obtained on April 10, 1994

  30. Radar Shadow • Shadows in radar images can enhance the geomorphology and texture of the terrain. Shadows can also obscure the most important features in a radar image, such as the information behind tall buildings or land use in deep valleys. If certain conditions are met, any feature protruding above the local datum can cause the incident pulse of microwave energy to reflect all of its energy on the foreslope of the object and produce a black shadow for the backslope • Unlike airphotos, where light may be scattered into the shadow area and then recorded on film, there is no information within the radar shadow area. It is black. • Two terrain features (e.g., mountains) with identical heights and fore- and backslopes may be recorded with entirely different shadows, depending upon where they are in the across-track. A feature that casts an extensive shadow in the far-range might have its backslope completely illuminated in the near-range. • Radar shadows occur only in the cross-track dimension. Therefore, the orientation of shadows in a radar image provides information about the look direction and the location of the near- and far-range

  31. Shadows and look direction Shuttle Imaging Radar (SIR-C) Image of Maui

  32. Major Active Radar Systems • Seasat, June 1978, 105 days mission, L-HH band, 25 m resolution • SIR-A, Nov. 1981, 2.5 days mission, L-HH band, 40 m resolution • SIR-B, Oct. 1984, 8 days mission, L-HH band, about 25 m resolution • SIR-C, April and Sept. 1994, 10 days each. X-, C-, L- bands multipolarization (HH, VV, HV, VH), 10-30 m resolution • JERS-1, 1992-1998, L-band, 15-30 m resolution (Japan) • RADARSAT, Jan. 1995-now, C-HH band, 10, 50, and 100 m (Canada) • ERS-1, 2, July 1991-now, C-VV band, 20-30 m (European) • AIRSAR/TOPSAR, 1998-now, C,L,P bands with full polarization, 10m • NEXRAD, 1988-now, S-band, 1-4 km, • TRMM precipitation radar, 1997, Ku-band, 4km, vertical 250m (USA and Japan)

More Related