1 / 8

LARP Phase II Secondary Rotatable Collimator

LARP Phase II Secondary Rotatable Collimator. 5 minute status report April 26th, 2010. SPS Tank and BPM housings. Resting on Base Plate. RF Foils. BeCu and Glidcop 0.25 and 0.2mm thick. Rotator mounted to Jaw. Rotator/actuator set-up for prototype tests.

chad
Télécharger la présentation

LARP Phase II Secondary Rotatable Collimator

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. LARP Phase II Secondary Rotatable Collimator 5 minute status report April 26th, 2010

  2. SPS Tank and BPM housings

  3. Resting on Base Plate

  4. RF Foils • BeCu and Glidcop 0.25 and 0.2mm thick

  5. Rotator mounted to Jaw

  6. Rotator/actuator set-up for prototype tests http://www-project.slac.stanford.edu/ilc/larp/rc/Photos/2010-04-22_rotation_mechanism_test/DSCN2398.MOV http://www-project.slac.stanford.edu/ilc/larp/rc/Photos/2010-04-22_rotation_mechanism_test/DSCN2400.MOV

  7. Next :Rotator qualification • Align Rotator worm with respect to Jaw facet and pin worm to axle • Grip inlet cooling tube and twist to test Rotator “stiffness” and facet backlash • Grip outlet cooling tube and twist together with the inlet tube to simulate total backlash load • Grip inlet cooling tube and actuate Motor drive to rotate Jaw against half the torque load • Add outlet tube and repeat for total load required on Ratchet Actuator and Rotator

  8. Coming up: • Mount RF Foils to RF bearings and determine which material and thickness is most suitable • Weld Flanges on to BPM Housings • Mount both Jaws, Tank and BPMs for Stretched Wire tests

More Related