1 / 31

IGARSS 2011 Vancouver 29 July 2011

IGARSS 2011 Vancouver 29 July 2011 Christopher Buck , Miguel Aguirre, Craig Donlon, Daniele Petrolati, Salvatore D’Addio ESA/ESTEC. STEPS TOWARDS THE PREPARATION OF A WAVEMILL MISSION. Wavemill Concept.

chico
Télécharger la présentation

IGARSS 2011 Vancouver 29 July 2011

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. IGARSS 2011 Vancouver 29 July 2011 Christopher Buck, Miguel Aguirre, Craig Donlon, Daniele Petrolati, Salvatore D’Addio ESA/ESTEC STEPS TOWARDS THE PREPARATION OF A WAVEMILL MISSION

  2. Wavemill Concept • Wavemill is an RF instrument concept which uses hybrid (along- and across-track) interferometry for the direct measurement of 2D ocean surface currents • Potential additional applications include inland water: lake height, river flow rate and ice freeboard • The TRP funded feasibility study generated very promising results suggesting accuracies of better than 10cm/s and 5° for dual swaths of 100km to either side of the sub-satellite track • On-board processing is required to reduce the high data rate and a breadboard activity for this is reserved in the current TRP work plan • The antenna development is also in the TRP work plan • A demonstration campaign will take place in the autumn, funded by EOP • EOP is also funding a mission study (phase 0) which will capitalize on the findings of the scientific analysis to be covered in a soon to start GSP activity

  3. Wavemill Concept The basis is a wide swath interferometric SAR instrument Operating in Ku band with a 100MHz bandwidth and a PRF of 2700Hz The antenna configuration is such that there is a separation of the antennas in both the across- and along-track directions 2D current measurements and topography mapping will be possible in a single pass The asymmetry of the viewing geometry permits some estimation of the baseline errors

  4. Wavemill Operation to Orbit Height ~550 km Flight Direction Sub-Satellite Track 90 km 3 km 100 km 280 km

  5. Wavemill Operation to Orbit Height ~550 km Flight Direction Sub-Satellite Track 90 km 3 km 100 km 280 km

  6. Wavemill Operation to Orbit Height ~550 km Flight Direction Sub-Satellite Track 90 km 3 km 100 km 280 km

  7. Wavemill Operation to Orbit Height ~550 km Flight Direction Sub-Satellite Track 90 km 3 km 100 km 280 km

  8. Wavemill Operation Orbit Height ~550 km Flight Direction Sub-Satellite Track 90 km 3 km 100 km 280 km

  9. Wavemill Operation Orbit Height ~550 km Flight Direction Sub-Satellite Track 90 km 3 km 100 km 280 km

  10. Wavemill Operation Orbit Height ~550 km Flight Direction Sub-Satellite Track 90 km 3 km 100 km 280 km

  11. Wavemill Operation Orbit Height ~550 km Flight Direction Sub-Satellite Track 90 km 3 km 100 km 280 km

  12. Wavemill Operation Orbit Height ~550 km Flight Direction Sub-Satellite Track 90 km 3 km 100 km 280 km

  13. Wavemill Operation Orbit Height ~550 km Flight Direction Sub-Satellite Track 90 km 3 km 100 km 280 km

  14. Wavemill Operation Orbit Height ~550 km Flight Direction Sub-Satellite Track 90 km 3 km 100 km 280 km

  15. Wavemill Operation Orbit Height ~550 km Flight Direction Sub-Satellite Track 90 km 3 km 100 km 280 km

  16. Wavemill System Parameters • On-board (burst) SAR processing up to generation of multi-look interferograms • A total of 8 interferograms generated on board • Total computational power < 45 GOPS • Baseline calibration, phase separation & L2 products processed on ground

  17. Scientific Requirements OCEAN SURFACE CURRENT REQUIREMENTS

  18. Ocean Challenges • To quantify the interaction between variability in ocean dynamics, thermo-haline circulation, sea level and climate • To understand physical and bio-chemical air/sea interaction processes • To understand internal waves and the ocean mesoscale, its relevance to heat and energy transport and its influence on primary productivity • To quantify marine eco-system variability, its natural and anthropogenic physical, biological and geochemical forcing • To understand land/ocean interaction in terms of natural and anthropogenic forcing • To provide both model- and data-based assessments and predictions of past, present and future states of the oceans

  19. Cryosphere Challenges • Quantify the distribution of sea-ice mass and freshwater equivalent, assess the sensitivity of sea-ice to climate change and understand thermodynamic and dynamic feedback [systems] to the ocean and atmosphere • Quantify the mass balance of grounded ice sheets, ice caps and glaciers, partition their relative contributions to global eustatic sea-level change and understand their future sensitivity to climate change through dynamic processes • […] • Quantify the influence of ice shelves, high-latitude river run-off and land ice melt on global thermo-haline circulation, and understand the sensitivity of each of these freshwater sources to future climate change • […]

  20. Land Challenges • Understand the role of terrestrial ecosystems and their interaction with other components of the Earth system for the exchange of water, carbon and energy, including the quantification of the ecological, atmospheric, chemical and anthropogenic processes that control these biochemical fluxes • […] • Understand the pressure caused anthropogenic dynamics on land surfaces (use of natural resources, land use and land-cover change) and their impact on the functioning of terrestrial ecosystems • […]

  21. Scientific Objectives

  22. Feasibility Study • TRP funded activity won by Starlab with Astrium and IFREMER • KO Jan 2008 tasks were: • Determination of Scientific Requirements • System Analysis • Instrument Design • Results were encouraging, CCN initiated to investigate ‘javelin’ concept using ‘leaky wave’ antennas • Completed July 2010 • Outcome of completed study plus CCN: • Basic scientific requirements for ocean currents • First cut instrument and spacecraft designs

  23. Proof of Concept Campaign • EOEP funded activity • KO 9 May 2011 • Tasks: • Prepare existing airborne interferometric SAR system for Wavemill operation (squinted beams preferably fore and aft) • Fly campaign over region with ground truth (HF radar, ADCPs, bathymetry) • Campaign flights over Liverpool Bay end September/beginning October 2011 • Process hybrid and co-time data, extract surface currents • Compare and validate results/instrument/processing and provide recommendations for spaceborne instrument • Workshop - release data to scientific community

  24. End-to-end Simulator • Development by Starlab (E) due to accrued know-how and proven competence in the development of relevant simulators (GNSS-R and WSOA) • Structure: • Instrument model with configurable parameters (baselines, bandwidths, squint and look angles etc) • Sea surface state model (SWH, wind direction and strength, swell, fetch etc) • Processing (hybrid, co-time, interferogram generation, flattening etc) • KO 5 July 2011, duration 18 months

  25. Product Assessment Study • GSP activity to be initiated Q3 2011 • Tasks: • Review of Along-Track Interferometry – capability of ATI for current measurement, existing models, impact of wind and mitigation thereof • Validity of Scientific Products from a Wavemill Instrument • Scatterometry – extracting wind speed from Wavemill amplitude data • Additional Products – sea-ice, inland water/rivers • Synergy with other Instrument Data (e.g. conventional altimeter, thermal imager etc)

  26. Mission Requirements Feasibility Study PoC Campaign Product Assessment Study Simulator MRD System Study

  27. Risk Retirement Activities In current TRP/GSTP plan: • Antenna breadboard • “Leaky wave” design – naturally squinted beams • On-board processing breadboard activity to cover the full on-board processing steps for Wavemill including: • SAR processing • Image registration • Co-time interferogram generation • Multi-looking • Flat earth correction • Hybrid interferogram generation • Hybrid phase separation Based on FFT and processing chipsets (e.g. PowerFFT, Leon II)

  28. Wavemill Instrument • 2 in-line antenna structures • Fore and aft beam footprints • Broadside orientated to sub-sat. track • Leaky-wave array concept

  29. Planning

  30. More on Wavemill • Advanced RF Sensors and Instruments Workshop, ESA/ESTEC. 12-15 September 2011 • Discussion group set up on LinkedIn – ‘Wavemill’ • Wavemill Science Workshop – December 2011/January 2012 at ESTEC • IGARSS 2012, Munich

  31. Wavemill Thank you for your attention! SMOS Final Anomaly Review Board ESTEC – PLSO 9, November 2010

More Related