1 / 6

ATLAS BIS MDT wiring facility

ATLAS BIS MDT wiring facility. UNIVERSITY OF ATHENS. D. Fassouliotis P. Ioannou C. Kourkoumelis V. Pancheluga D. Pappas E. Stefanidis V. Birioukov (engineer from Protvino). Visit our web-page at: http://www.phys.uoa.gr/Atlas/MDT. AIM: Wire/check all the Monitored

dung
Télécharger la présentation

ATLAS BIS MDT wiring facility

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. ATLAS BIS MDTwiring facility UNIVERSITY OF ATHENS • D. Fassouliotis • P. Ioannou • C. Kourkoumelis • V. Pancheluga • D. Pappas • E. Stefanidis • V. Birioukov (engineer from Protvino) Visit our web-page at: http://www.phys.uoa.gr/Atlas/MDT

  2. AIM: Wire/check all the Monitored Drift Tubes for the ATLAS BIS chambers 30,000 !! Tubes – 128 chambers (8 layers) Construction specifications……: Wire position ± 25 μm Wire tension 350 ± 15 gr Gas leak rate < 10-8 bar*l/sec at 3 bar Leak at 3.4 kV (gain 1.6*105) < 2nA/m ……necessary to achieve such physics results : H  μμμμ

  3. TO ACCOPLISH AIM: • Build a clean room • 20±1 oC • Class 50,000 • Develop a wiring table+wiring tools • Flat top • Tube holders • Alignment of two end-plug-holders • End-plug insertion (coaxility tube/end-plug) • Tube pressure crimping • Speed of wire threading • Wire tensioning • Develop on-line QA of tube construction • parameters • Length check • End-plug/tube axis coaxiality • Wire tension • SITE WAS CERTIFIED ON MAY 1999

  4. CERN Bulletin 33/99; 16 August 1999 First ATLAS muon chamber arrives from Greek production line Greek delegate to CERN Council, Professor Emmanuel Floratos (front, centre), accompanied by members of the Greek team, with the first ATLAS muon chamber built in Greece installed in the x-ray tomograph at CERN. …the first precision chamber to come off a production line was built by a collaboration of three Greekuniversities and it arrived at CERN from Thessaloniki on 5 August. This chamber is the first complete model of 1200 that will be built around the world over the next few years.….

  5. FIRST CHAMBER FROM 17 SITES IN 9 COUNTRIES TO PASS ALL TESTS (13 μm position fluctuation of wire) Verifying the alignment of interferometer beam optics on the ATLAS experiment's X-ray tomograph at CERN. A small muon chamber from Greece, destined for the barrel region of the detector, is on the tomograph. It went on to pass the test with its wires showing an average fluctuation of just 13 mm from their nominal positions. To pass the test, a chamber has to score less than 20 mm. CERN Courier, October 2000

  6. The tools we use …. …Micromechanics Electronics… …Automation

More Related