1 / 7

Quality Control

Quality Control. Bushong Chapter 10. QC. The CT number of water should be 0 Scan a water phantom, select a large enough region of interest (ROI), the average CT number should be within +/- 3

long
Télécharger la présentation

Quality Control

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Quality Control Bushong Chapter 10

  2. QC • The CT number of water should be 0 • Scan a water phantom, select a large enough region of interest (ROI), the average CT number should be within +/- 3 • Scan an empty gantry aperture, select a large ROI, the average CT number for air should be within -1000 +/- 5

  3. QC • CT noise is evaluated by scanning a water bath. The standard deviation should not exceed +/- 10 • Spatial resolution is evaluated by scanning any number of phantoms-hole patters, or line pair patterns • Spatial resolution should be at least equal to the manufacturers specifications

  4. QC • Most CT imagers can image .5mm (10 lp/cm), some as good as .2mm (20 lp/cm) in a high resolution mode • Contrast resolution is evaluated with either a phantom, thick or thin, various hole sizes filled with water, or various hole sizes of various depth for partial volume effects • Contrast resolution should be at least 5mm at 5% contrast

  5. QC • Distance measurement accuracy is evaluated by imaging the American Association of Physicists in Medicine (AAPM) test object that has pins separated by 10mm • The electronic distance calipers must be accurate to within +/- 5%

  6. QC • The video monitor should be evaluated for distortion by pressing a clear plastic rules against the screen image of the 10mm pin test object to ensure the same 5% accuracy • Scan plane localization, usually a laser light localizer, should be accurate to within 1mm. A number of test devices are available

  7. QC • Patient couch indexing can be checked with cardboard wrapped film or marks on the couch and rail. The limit of error is 1% • Slice width is usually evaluated with a ramp test object and should be within 50% for nominal widths of 5mm and above and 100% for thinner slices

More Related