1 / 102

Sorry that is Incorrect. Go Back and Try Again.

#4773. When tracking inbound on the localizer, which of the following is the proper procedure regarding drift corrections?.

Télécharger la présentation

Sorry that is Incorrect. Go Back and Try Again.

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. #4773. When tracking inbound on the localizer, which of the following is the proper procedure regarding drift corrections? A- Drift corrections should be accurately established before reaching the outer marker, and completion of the approach should be accomplished with heading corrections no greater than 2 degrees. B- Drift corrections should be made in 5 degree increments after passing the outer marker. C- Drift corrections should be made in 10 degree increments after passing the outer marker.

  2. Sorry that is Incorrect. Go Back and Try Again.

  3. That’s Right!!! Next Question

  4. #4412. What is the meaning of a single coded identification received only once approximately every 30 seconds from a VORTAC? A- The VOR and DME components are operative. B- VOR and DME components are both operative, but voice identification is out of service. C- The DME component is operative and the VOR component is inoperative.

  5. Sorry that is Incorrect. Go Back and Try Again.

  6. That’s Right!!! Next Question

  7. #4552. A VOR receiver with normal 5-dot course sensitivity, shows a 3-dot deflection at 30 NM from the station. The aircraft would be displaced approximately how far from the course centerline? A- 2 NM. B- 3 NM. C- 5 NM.

  8. Sorry that is Incorrect. Go Back and Try Again.

  9. That’s Right!!! Next Question

  10. #4551. When checking the sensitivity of a VOR receiver, the number of degrees in course change as the OBS is rotated to move the CDI from center to the last dot on either side, should be between A- 5 and 6 degrees. B- 8 and 10 degrees. C- 10 and 12 degrees.

  11. Sorry that is Incorrect. Go Back and Try Again.

  12. That’s Right!!! Next Question

  13. #4601. The course selector of each aircraft is set on 360 degrees. Which aircraft would have a FROM indication on the ambiguity meter and CDI pointing left of center?See fig 106. A- 1. B- 2. C- 3.

  14. Sorry that is Incorrect. Go Back and Try Again.

  15. That’s Right!!! Next Question

  16. #4606. In which general direction from the VORTAC is the aircraft located? A- Northeast. B- Southeast. C- Southwest.

  17. Sorry that is Incorrect. Go Back and Try Again.

  18. That’s Right!!! Next Question

  19. #4549. When using VOR for navigation, which of the following should be considered as station passage? A- The first movement of the CDI as the airplane enters the zone of confusion. B- The moment to TO-FROM indicator becomes blank. C- The first positive, complete reversal of the TO-FROM indicator.

  20. Sorry that is Incorrect. Go Back and Try Again.

  21. That’s Right!!! Next Question

  22. #4488. Which combination of indications confirm that you are approaching WAGGE intersection slightly to the right of the LOC centerline on departure? Use fig. 85 &86. See next two slides A- 1 and 3. B- 1 and 4.C- 2 and 3.

  23. Sorry that is Incorrect. Go Back and Try Again.

  24. That’s Right!!! Next Question

  25. #4347. What is your position relative to the FLOSI intersection northbound on V213? See Fig 71, 71a., See next slide A- West of V213 and approaching the FLOSI intersection. B- East of V213 and approaching the FLOSI intersection. C- West of V213 and past the FLOSI intersection.

  26. Sorry that is Incorrect. Go Back and Try Again.

  27. That’s Right!!! Next Question

  28. #4591. If the magnetic heading shown for airplane 7 fig 105, is maintained, which ADF illustration would indicate the airplane is on the 120 degree magnetic bearing FROM the station? A- 2 B- 4.C- 5.

  29. Sorry that is Incorrect. Go Back and Try Again.

  30. That’s Right!!! Next Question

  31. #4578. What is the magnetic bearing TO the station? Refer to fig. 101. A- 060 degrees. B- 260 degrees. C- 270 degrees.

  32. Sorry that is Incorrect. Go Back and Try Again.

  33. That’s Right!!! Next Question

  34. #4598. If the magnetic heading of 315 deg. shown for airplane 8 (fig 105.) is maintained, which ADF illustration would indicate the airplane is on the 090 degree magnetic bearing FROM the station? A- 3. B- 4.C- 6.

  35. Sorry that is Incorrect. Go Back and Try Again.

  36. That’s Right!!! Next Question

  37. #4585. The magnetic bearing FROM the station would be (fig 103.) A- 030 degrees. B- 060 degrees. C- 240 degrees.

  38. Sorry that is Incorrect. Go Back and Try Again.

  39. That’s Right!!! Next Question

  40. #4593. If the magnetic heading shown for airplane 3 (fig 105.) is maintained, which ADF illustration would indicate the airplane is on the 120 degree magnetic bearing TO the station? A- 4. B- 5. C- 8.

  41. Sorry that is Incorrect. Go Back and Try Again.

  42. That’s Right!!! Next Question

  43. #4281. What is your position relative to the CONNY intersection on the BUJ.BUJ3 transition?(fig. 35 & 37) A- Left of the TXK R-272 and approaching the BUJ R-059. B- Left of the TXK R-266 and past the BUJ R-065. C- Right of the TXK R-270 and approaching the BUJ R-245.

  44. Sorry that is Incorrect. Go Back and Try Again.

  45. That’s Right!!! Next Question

  46. #4580. What is the magnetic bearing TO the station?(Fig 100.) A- 285 degrees. B- 055 degrees. C- 235 degrees.

  47. Sorry that is Incorrect. Go Back and Try Again.

  48. That’s Right!!! Next Question

  49. #4589. If the radio magnetic indicator is tuned to a VOR, which illustration indicates the aircraft is on the 315 radial? Fig 104 Pg. 72 of Course Summary. A- 2. B- 3. C- 4.

  50. Sorry that is Incorrect. Go Back and Try Again.

More Related