1 / 9

Use of Multimeter

Use of Multimeter. Outlook of Multimeter. Pointer and Scale single pointer with different scale for different measurements. Selection Switch select to measure voltage (ac or dc), current or resistance. Reading from Multimeter.

briano
Télécharger la présentation

Use of Multimeter

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Use of Multimeter

  2. Outlook of Multimeter • Pointer and Scale • single pointer with different scale for different measurements • Selection Switch • select to measure voltage (ac or dc), current or resistance.

  3. Reading from Multimeter • As the Selection Switch is at DC25mA, the multimeter is used as a ammeter with fsd 25mA. • The 250A scale is used. • Reading = 17.5mA The Mission Covenant Church Holm Glad College

  4. Using as an Ohmmeter • With the input terminals shorted, set zero by turning the 0 Adjust Knob. • Remember to set zero again if the ohmmeter range is changed.

  5. Reading from Multimeter • As the Selection Switch is at x10, the reading has to be multiplied by 10. • The reading is 90, so the resistance is 900  .

  6. Measuring AC Voltage • If AC voltage is measured, remember to use the “output “ terminal instead of the “positive” terminal. • The “negative” terminal is still used.

  7. Digital Multimeter • Same as analogue multimeter but it has the advantage of having a large internal resistance. • If the reading is larger than the range, the reading cannot be shown. • The “COM” terminal is always used. The other terminal can be “10A”, “AmA”, “V” depending on the measurement.

  8. Digital Ohmmeter • In the figure shown, the resistance of the resistor is 0.824k. • There is no need to multiplied 2k for digital ohmmeter as it is the range, but not the conversion factor. The Mission Covenant Church Holm Glad College

  9. Measuring AC/DC • Make sure that the switch is switched to the correct side for DC or AC measurement. AC DC

More Related