1 / 14

Facing on the Centre Lathe

Facing on the Centre Lathe. Centre Lathe. Safety Guard. Chuck. Tailstock. The picture on the left shows a Centre Lathe which is used for turning metals. Bed. Headstock. Compound Slide. Cross Slide. Toolpost. Saddle wheel. The main parts are as shown. Emergency Stop. Facing a Bar.

arnie
Télécharger la présentation

Facing on the Centre Lathe

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Facing on the Centre Lathe

  2. CentreLathe Safety Guard Chuck Tailstock The picture on the left shows a Centre Lathe which is used for turning metals Bed Headstock Compound Slide Cross Slide Toolpost Saddle wheel The main parts are as shown EmergencyStop

  3. Facing a Bar First of all fix the bar in the chuck with the chuck key.

  4. Facing a Bar To Face the end of this bar start by lowering the Safety Guard

  5. Facing a Bar Now use the Saddle Wheel to move the tool closer to the workpiece

  6. Facing a Bar Next use the Compound slide to move the toolpost in until it is ready to cut

  7. Facing a Bar Now switch On the lathe

  8. Facing a Bar Finally use the cross slide to pass the lathe tool across the face of the bar taking a fine even paced cut.

  9. Facing a Bar Switch the Lathe Off

  10. Facing a Bar Use the Saddle wheel to return the lathe tool to its original position then lift the guard.

  11. This process may have to be repeated more than once

  12. Process Completed Well Done

  13. CentreLathe Safety Guard Chuck Tailstock The picture on the left shows a Centre Lathe which is used for turning metals Bed Headstock Compound Slide Cross Slide Toolpost The main parts are as shown Saddle wheel EmergencyStop Back

  14. Wrong Click here to try again

More Related