1 / 13

CSC Endcap Muon Port Card and Muon Sorter Status Mikhail Matveev Rice University

CSC Endcap Muon Port Card and Muon Sorter Status Mikhail Matveev Rice University. MPC Upgrade Requirements . ■ Be able to deliver all 18 trigger primitives from the EMU peripheral crate to the upgraded Sector Processor ■ Preserve sorting capabilities of the Muon Port Card

nitza
Télécharger la présentation

CSC Endcap Muon Port Card and Muon Sorter Status Mikhail Matveev Rice University

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. CSC EndcapMuon Port Cardand Muon Sorter StatusMikhail MatveevRice University

  2. MPC Upgrade Requirements ■ Be able to deliver all 18 trigger primitives from the EMU peripheral crate to the upgraded Sector Processor ■ Preserve sorting capabilities of the Muon Port Card ■ Preserve 3 old 1.6Gbps optical links to the existing CSCTF US CMS EndcapMuon Meeting, TAMU 30 September - 1 October 2013

  3. Upgrade Developments • Use existing Muon Port Card main board - TMB interface remains unchanged (2 LCTs per TMB @ 80MHz) - 3 “old” optical links are still available • Original design (2004) was based on Xilinx Virtex-E XCV600E FPGA • New prototype (2012) is based on Xilinx Spartan-6 FPGA - Inexpensive FPGA ($280 for the fastest speed grade XC6SLX150T-3FG900C device) - 8 embedded GTP serializers - 3.2Gbps/channel data rate - Modest power consumption (~1A Vccint; <1A GTPs) - Pluggable 12-channel optical transmitter US CMS Endcap Muon Meeting, TAMU 30 September - 1 October 2013

  4. New Spartan-6 Mezzanine Top Bottom Pluggable optical transmitter • Three MPC main boards are equipped with new mezzanines • (Rice, UF, bld.904 – test stand for ME2/1) US CMS Endcap Muon Meeting, TAMU 30 September - 1 October 2013

  5. Optical Transmitter SNAP12 transmitter Avago AFBR-810 transmitter • SNAP12 and Avago AFBR-810 are pluggable 12-channel devices • Both use the same 10x10 low profile circuit, but pin assignment • is different (Avago is intended for higher data rate, needs 3.3V and 2.5V power) • ■ uTCA MTF6 uses Avago AFBR-820 receiver, so the Avago AFBR-810 transmitter is our primary choice US CMS Endcap Muon Meeting, TAMU 30 September - 1 October 2013

  6. Optical Tests at Rice, 2012-2013 • Three MPC boards with the • new mezzanines • SP10 prototype • Test software is available, • various PRBS and random patterns • Random patterns from MPC FIFO to SP10 FIFO under • slow VME control: 10K iterations (510 frames each); • no errors, all boards • PRBS tests OK, BER<10-13 MPC SP10 CCB US CMS Endcap Muon Meeting, TAMU 30 September - 1 October 2013

  7. Measurements ■ Latency: ■ Power consumption: - Spartan-6 FPGA ~1A Vccint (1.2V) ~0.15A Vccaux+Vcco (3.3V) ~ 0.8A GTPs (1.2V) - MPC (main board + Spartan-6 mezzanine) <4A @ 3.3V US CMS Endcap Muon Meeting, TAMU 30 September - 1 October 2013

  8. Optical Fibers for P.5 ● Trunk cable with 4 connectorizedcords (similar to one proposed for the DT upgrade). Each cord has 12 fibers. Need 36 cables for 60 peripheral crates, one spare cord per crate. ● Cable sample was successfully tested at UF in April 2013 ● Purchase order ($81.3K CHF) has been placed through CERN in April 2013, expected delivery in October 2013. Will be checked by CERN experts. Installation by a CERN team. US CMS Endcap Muon Meeting, TAMU 30 September - 1 October 2013

  9. Irradiation Tests, April 2013 XCF32P PROM Spartan-6 FPGA (rear side) ■ EPROM was tested at TAMU cyclotron - Irradiated with 1 MeV equivalent fluence at ~10.5*1012 equivalent to ~30kRad, or 30 years of LHC exposure in ME1/1 area - Device was read back; not a single bit change, as expected ■ Spartan-6 was irradiated at the UC Davis cyclotron - Cross section of SEU = 2.5x10-9 cm2 , or 1 SEU in ~ 5.5 hours per device - Irradiated with ~100 kRad at a rate of 360 Rad/sec; the device survived and was functional US CMS Endcap Muon Meeting, TAMU 30 September - 1 October 2013

  10. New MPC-to-SP Data Format How to squeeze 18 LCTs from 9 CSCs into 8 fibers at 3.2Gbps? • ■ Proposal from Lev Uvarov, June 2013: • Preserve existing LCT format for all CSCs • Put CSCs 2-9 into fibers 1-8 • Split CSC 1 between fibers 1-8; 7 bits per each fiber • ■ This idea has been recently implemented in the MPC firmware and tested • internally (FIFO-to-FIFO transmission) US CMS Endcap Muon Meeting, TAMU 30 September - 1 October 2013

  11. Preparations for Mass Production ■ Purchased 3 samples of optical pigtail from CERN. Ordered 80 more. ■ Purchased 80 optical couplers to be installed on the front panels ■ Fabricated 80 new front panels ■ Minor layout change in the optical transmitter board has been done. PCBs are being fabricated. ■ Need 2...3 minor changes in the mezzanine design ■ Ordered critical parts for 80 boards (optical transmitters, FPGA). Estimated delivery is mid November. US CMS Endcap Muon Meeting, TAMU 30 September - 1 October 2013

  12. MPC Near Future Plans ■ Need to set up a test stand at Rice: Track Finder VME crate (exists) - MPC, SP05, CCB, TTCvi/vx (all exist) New uTCA crate (exists) - controller, AMC13 card, MTF6 Software to run uTCA ■ Will need similar test stand in bld.904 at CERN by summer 2014 US CMS Endcap Muon Meeting, TAMU 30 September - 1 October 2013

  13. Muon Sorter Upgrade ■ Upgraded mezzanine board with Virtex-5 XC5VLX110T-2FF1136C FPGA - Fully compatible with the existing main board (3.3V logic levels, 640 I/O) - 16 embedded GTP links, up to 3.75Gbps data rate - One muon fits one GTP link at 3.2Gbps ■ Optical transmitter to the interim calorimeter trigger (4 muons) - Optical standard (SNAP12, QSFP, Avago AFBR-820/810…)? - Data rate and format? - Any other optical links (uTCA GMT…)? ■ Schedule and tests (when and where?) US CMS Endcap Muon Meeting, TAMU 30 September - 1 October 2013

More Related