1 / 18

Brittle Deformation

Brittle Deformation. Remember that q is the angle between s 3 and a plane. Definitions. Differential Stress: Difference between largest and smallest stresses Deviatoric Stress: Difference between total stress and mean stress. s 1. Magnitude of Normal and Shear Stresses. Normal.

aglaia
Télécharger la présentation

Brittle Deformation

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Brittle Deformation Remember that q is the angle between s 3 and a plane

  2. Definitions Differential Stress: Difference between largest and smallest stresses Deviatoric Stress: Difference between total stress and mean stress.

  3. s1 Magnitude of Normal and Shear Stresses Normal s3 Shear

  4. What does this mean for fractures? Fractures will form when sn is low but ss is high. • is usually 60° when fractures form

  5. Coulomb Fracture Criterion predicts failure in rock: ss = sntanf fis the angle of internal friction tan fis the coefficient of internal friction Rocks: Avg. is 0.6 C is the point at which sn = 0 T is the point at which ss = 0 q= 90° -2f

  6. Shaded area is stable (No brittle failure) Failure No failure

  7. Sketch two cross sections: In one, 1 is horizontal, 3 vertical What is the dip of the fault predicted by this model? In the other 3 is horizontal, 1 vertical . What is the dip of the fault? Remember that q is the angle between s 3 and the plane. See also fig. 6.16. Exercise

  8. Once a fracture exists deformation continues by frictional sliding or cataclastic flow Frictional Sliding

  9. CCW Rotation

  10. Formation of Shear Fractures 2 faults form 1 fault stays active s3 s1

  11. These two are not faults. Crack is Parallel to 1

  12. Shallow crust Deep crust

  13. Non-frictional sliding on Fault surface: Calcite fibers from fluids in fault zone

More Related