1 / 21

Lecture 8 Transistors

Lecture 8 Transistors. CSCE 211 Digital Design. Topics Review: Combinational Circuits Decoders Multiplexers Breadboards, LEDs Components on integrated circuit (ICs) Transistors CMOS Readings 5.4, 5.7. September 29, 2014. Hot Batteries.

jacob
Télécharger la présentation

Lecture 8 Transistors

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. Lecture 8Transistors CSCE 211 Digital Design • Topics • Review: • Combinational Circuits • Decoders • Multiplexers • Breadboards, LEDs • Components on integrated circuit (ICs) • Transistors • CMOS • Readings 5.4, 5.7 September 29, 2014

  2. Hot Batteries • You should regularly check your batteries “slightly warm” is OK but hot indicates that your circuit has a short circuit. • Unplug quickly and check. • Look for direct lines Vcc to GND. • Remember you need 330 ohm resistors in series with LEDs and that includes segments of the seven segment display. • Recheck sections of the breadboard.

  3. Transistor: Water Flow Model Water flow in B raises the plunger so that water can flow from C to E. Small flow turns on and off bigger flow. Put signal on B, transfer signal C to E Reference: http://www.satcure-focus.com/tutor/page4.htm

  4. Transistor Terminology • Conductor – electrons easily passed from one atom to next (copper every atom has loose electron) • Insulator – electrons tightly tied down to atoms, no flow • Semiconductor – by adding impurities (doping) can be changed to increase conductivity • Silicon wafer – used for IC circuits • N-type - silicon doped with boron (excess electrons) • P-ype - silicon doped with phosphorous (excess “holes” lack of electrons)

  5. Transistor Reference: http://www.intel.com/education/transworks/

  6. Transistor Reference: http://www.intel.com/education/transworks/

  7. Transistor Put Positive charge on gate. This attracts electrons into gap. This allows electrons to pass freely through the gap. Reference: http://www.intel.com/education/transworks/

  8. Transistor Reference: http://www.intel.com/education/transworks/

  9. Transistor Take positive charge off Gate This stops attracting electrons. This shuts off the flow. Reference: http://www.intel.com/education/transworks/

  10. N channel transitor

  11. P channel Transistor

  12. CMOS Inverter

  13. CMOS NAND

  14. What’s This?

  15. High impedance • High impedance is the state of an output terminal which is not currently driven by the circuit; neither high nor low • Like an unconnected wire • It is also known as hi-Z, tri-stated, or floating http://en.wikipedia.org/wiki/High_impedance

  16. Tri-state Buffer In the tri-state buffer the enable input (B) acts as a switch Note if B is enabled then C=A and if B is not enabled then C = High-impedance http://en.wikipedia.org/wiki/Three-state_logic

  17. Tri-state Buffer Implementation • .

  18. Transmission Gates (Fig 3.45) A is the input; B the output

  19. 2-to-1 Mux from transmission gates • .

More Related