Download
work holding and tool holding n.
Skip this Video
Loading SlideShow in 5 Seconds..
Work Holding and Tool Holding PowerPoint Presentation
Download Presentation
Work Holding and Tool Holding

Work Holding and Tool Holding

528 Vues Download Presentation
Télécharger la présentation

Work Holding and Tool Holding

- - - - - - - - - - - - - - - - - - - - - - - - - - - E N D - - - - - - - - - - - - - - - - - - - - - - - - - - -
Presentation Transcript

  1. Work Holding and Tool Holding • Six degrees of freedom of a body/object in space • Principle of work/tool holding (location and restraint) • Example of work holding method

  2. Six degrees of freedom • If we consider a body/object in space it is free to move in six directions as follows: • Back and forth along the X axis • Side to side along the Y axis • Up and down in the Z axis • Rotate either way about the X axis • Rotate either way about the Y axis • Rotate either way about the Z axis

  3. Principle of location and restraint • To be able to carry out work on the material/object it is necessary to locate the material in a set position on the machine and restrain it using some form of clamping/fixing device to prevent any linear or rotational movement. • The clamping/fixing devices can consist of: • (A) positive restraints, where a physical object prevents the material from moving. • (B) frictional restraints, where the material is gripped between two or more objects. • (C) a combination of positive and frictional restraints. • Where possible a positive restraint should be used to resist cutting forces.

  4. Location and Restraint • If the material is placed on a flat surface as in diagram below some of its states of freedom become restrained

  5. When location pins are added as in diagram below it becomes further restrained and also located in set positions

  6. If clamping screws are then added as in diagram below the material becomes fully restrained and located in set positions

  7. Typical Example of a Work Holding Device (work held between centres on a lathe)