1 / 13

-Square Elbow with turning vanes

009-i. CHAPTER. -Square Elbow with turning vanes. Aluminium tape. Aluminium tape. W+200mm. Square elbow. LN. W+350mm. W+350mm. Cover bottom. Cover top. 1. D raw the template of the cover bottom and cut toward “EXTERNAL”. Square elbow. 2.

lyneth
Télécharger la présentation

-Square Elbow with turning vanes

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. 009-i CHAPTER -Square Elbow with turning vanes

  2. Aluminium tape Aluminium tape W+200mm Square elbow LN W+350mm W+350mm Cover bottom Cover top 1 • Draw the template of the cover bottom and cut toward “EXTERNAL”.

  3. Square elbow 2 • Cut the walls and make the female before of to glue.

  4. Square elbow Glue 3 • Glue all the sides cut at 45º

  5. Aluminium tape Square elbow Exterior face 4 • Unite the four sides with aluminum tape for the exterior.

  6. Square elbow Interior face 5 • Rotate the piece in position with the interior face up.

  7. Square elbow 6 • Close the first side in position 90º vertical.

  8. Square elbow 6 • Close the second side in position 90º vertical.

  9. Square elbow 7 • Close the third side.

  10. Square elbow 8 • Place the interior walls.

  11. Pressing Silicon inside Aluminium tape Square elbow 9 • To press, to tape, to clip and to make the male.

  12. Square elbow 10 • Insert the kit “Turning Vanes”.

  13. Nut M6 Reinforcement disk Tierod M6 Reinforcement disk Nut M6 Square elbow 10 • Insert the kit of “Turning Vanes”.

More Related