1 / 17

Universal Holding Cabinet

This guide provides detailed instructions for assembling and maintaining a Universal Holding Cabinet. It covers the securement of driver boards with screws, the removal and placement of the ON/OFF switch panel, and the sliding mechanism of the component shelf for easy access. It also explains how to remove bezel components, disconnect wiring, and secure heater plates with set screws. Follow these steps to ensure proper assembly and servicing of your cabinet for optimal performance and longevity.

yelena
Télécharger la présentation

Universal Holding Cabinet

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Universal Holding Cabinet Two screws hold each side; four screws secure the top.

  2. Driver boards

  3. The panel holding the ON/OFF switch can be removed and placed out of the way, allowing the component shelf to slide forward.

  4. Component shelf slid forward. Note panel on top of unit.

  5. Component shelf with top off

  6. Motherboard

  7. Control and heater plate connections

  8. Disconnecting display from driver board

  9. Control and heater plate wiring.

  10. The bezels are removed by loosening screws on the side of the unit.

  11. The bezel is slid from the cabinet.

  12. Bezel and connecting ribbon cable

  13. Slots, with front and rear bezels removed are disconnected from heat and control circuits and slid from cabinet.

  14. The heater plates are held in place in the slots by setscrews under the foil cover. Find the setscrews by tracing the edge of the slot with a finger.

  15. Puncture the foil with an allen wrench to remove the setscrew.

  16. Heater plate partially removed from slot.

  17. Heater plate and wires atop slot.

More Related